VIRIDIAN X5L Universal Mount Green Laser w/ Light (X5L)
To place an order email email@example.com. Copy and past the following into the subject line of your email: Interested in Open Box Item VIR-X5L. Alternatively, call 800-851-9329 between 8 am and 6 pm Central Standard Time to place your order.
This new laser trainer fits all of the most popular pistol calibers, mounts inside the barrel and has the sound activated switch showing bullet impact with a laser dot. Every time your hammer or striker fires the small laser dot will flash for 100 milli-seconds simulating bullet impact.
This is the next evolution to the LaserLyte line of laser trainers. This model installs from the muzzle of the barrel and fits tight with the use of LaserLyte’s patented arbor and taper system. The system will fit the weapons chambered in 9mm, 40S&W, 45 ACP that have a minimum of a 2 inch barrel. The LT-Pro will also fit calibers 38 special, .380 Auto, 357 Sig, 10 mm and 45 LC.
The training possibilities are expanded with this model because the trainer will not extend past your muzzle more than .25 inches. This nearly flush mounted laser trainer makes it easier to train from the holster, concealment or close quarters. The mounting system will retain the laser firmly in the barrel during any reloading drills. (LaserLyte strongly recommends the use of snap caps)
This is simply the easiest way to train without ammo for any of your pistols with a 2-inch barrel or longer. The popular calibers listed above can be expensive and hard to find for regular practice. This is the most effective laser training system that will meet all your needs.
• Minimum 2-inch barrel required
• Fits calibers: 9mm, 40s&w, .45acp, 38sp, .380 Auto, 357sig, 10mm and 45lc.
• Near flush fitting to muzzle design
• Allows more advanced training scenarios
• Hammer or striker fired laser activation for 100 milli-seconds
• Patented adjustment system
• Length: 2.1 inches
• Minimum diameter: .1 inch
• Maximum Diameter: .5 inch
• Run Time: 3,000 shots • Batteries: 3 x 377
• Activation: Sound of striker or hammer
LaserLyte® answers the growing demand for lasers specific to the increasingly popular conceal carry market with the new Ruger LCP Side Mount Laser (CK-AMF). At half the cost of a leading competitor, the CK-AMF fits on the side of the Ruger LCP and the Kel-Tec .380 and .32. Easy to mount on the gun by simply pushing out and replacing the stock pins with the new screws (included). Then push the ergonomic activation button with the index finger and the laser is on target. The CK-AMF design works also as a finger guide that allows for safe trigger control without blocking the laser beam. The programmable laser features a pulse or constant on mode and also has an auto-off function to prevent an unwanted battery drain. The side mounted laser allows the pistol to fit in virtually any nylon pocket holster. The new LaserLyte Ruger LCP Side Mount Laser is compact and light, and foremost – deadly
- Product Number: CK-AMF
- Compatible Firearms: Ruger LCP, Kel-Tec .380 and .32
- Power Output: Class IIIA, 5mw
- Laser module: 650nm
- Batteries: four 377 batteries
- Battery Life: 5 hrs. constant on, 10 hrs. pulse mode (normal usage)
- Weight (with plate): .25 ounces/ 9 grams
- Length/Width/Height: 3.65 in./92.71mm Width: .56 in./17.22 mm H: .380 in./9.65mm
- Range at Night: 500 yd., 457.2 m
LaserLyte® Returns to Basics with a very affordable rear sight laser for the Springfield XD/XD pistols.
LaserLyte® returns to basics with the patented RTB-XD rear sight laser that fits the Springfield XD/XDM firearms. The high performance laser built into a rear sight specifically designed for Springfield XD/XDM pistols features a simple, ambidextrous “press and go” activation. The laser is easily programmable to either constant on or pulse mode. Another great feature is the “auto-off” feature that displays a unique flash after 5-minutes of operation and automatically turns the unit off after 6-minutes.
Made from heavy-duty, high carbon steel for added durability, the LaserLyte RTB-XD rear sight laser has a black chrome finish for corrosion prevention. A great benefit of the LaserLyte RTB-XD rear sight laser is that the customer will not have to replace grips, internal stock parts or holsters. The LaserLyte RTB-XD rear sight laser is compatible with all Level 1 and Level 2 holsters including the BLACKHAWK!® SERPA® holster system.
*Does not fit XD(M) 5.25
LaserLyte RTB-XD Specifications:
-Compatible Firearms: Fits Springfield Armory XD/XDM pistols, Sig Sauer P225, P226, P228
As many know, laser sights can be very beneficial; but there is one major flaw… ordinary red lasers can be next to impossible to see in most daylight conditions. The benefit of a green laser is that it is much more visible, allowing for it to be used anytime, day or night, indoors or outdoors, permitting you to track your target quicker and more accurately. Additionally, because green lasers are so much more visible to the human eye, you can actually see a very intimidating visible beam in low-light conditions.
The Difference is Clear
During the Day
Which is more visible to you? On the left we see a traditional red laser sight, compared to the green Viridian in broad daylight. The lasers were at a distance of 25 feet from the wall.
On the left you can see how visible the beam can actually get during dark or dimmer conditions.
Overcast, In the woods
Shown to the left is an additional day shot, which again shows the dramatic difference.
Why Green Lasers are More Visible
Green is closer to the center of the visible spectrum, at 532 Nanometers, so it’s easier for our eyes to perceive the color vs. a red laser at 635 Nanometers. In fact, a green laser can appear as much as 50 times brighter than the red equivalent and as can be seen from the below charts 532 nm is the ideal wavelength to maximize visibility during day or night.
In Daytime Conditions the human eye has maximum sensitivity
at the 555 nm wavelength
In Nighttime Conditions the human eye has maximum sensitivity
of 512 nm wavelength
LaserLyte® answers the growing need for Zombie killer laser products with the side mount CK-AMFZK for the Ruger® LCP and Kel-Tec® .380 and the CK-AMF9ZK for the Ruger LC9 and Kel-Tec PF9. These new LaserLyte Zombie Killer Editions are easy to mount, easy to use, inexpensive to buy, and most of all, they are in a bright Zombie green.
The side lasers are easy to mount on the gun by simply pushing out and replacing the stock frame pins with the new threaded pins (included). Mount the CK-AMF9ZK or CK-AMFZK to these pins with the included screw. Then push the ergonomic activation button with the index finger and the laser is on target. The programmable laser features a pulse or constant on mode and also has an auto-off function to prevent an unwanted battery drain. An added benefit is that the laser actually helps to provide safer trigger control by acting as a finger guide without blocking the laser beam. The smooth, no-snag design of the laser allows the pistol to easily holster in any available nylon or leatherpocket holster on the market.
Compact, lightweight and easy-to-use, the LaserLyte® CK-AMF9ZK and CK-AMFZK give you the edge in close quarter Zombie situations for only $99.95, a price far lower than the competition, but far superior in quality.
LaserLyte® Introduces One Side Mount Laser that Fits All Taurus Revolvers and all S&W J-Frames; the LaserLyte® CK-SWAT
The side mounted laser fits on all of the Smith & Wesson J-frame revolvers ever made and all Taurus revolvers. And now, the Taurus Judges including the Public Defender finally has a laser system to call its own with the CK-SWAT laser.
The new LaserLyte® CK-SWAT laser mounts easily underneath the grip and is the only laser system available that allows the customer to retain the factory grip and comfortably and easily holster the firearm. The CK-SWAT is also compatible with many aftermarket grips including Hogue® and Pachmayr®.
To install the LaserLyte® CK-SWAT, simply choose one of the four included base plates that fit the revolver, remove the grip and screw the unit into place. Replace the grip and sight in the firearm with common X and Y adjustments. When ready to activate, simply press the button located at the back of the laser as you draw the firearm from the holster. The laser is easily programmable to either constant on or pulse mode.
Another great feature is the “auto-off” feature that displays a unique flash after 5-minutes of operation and automatically turns the unit off after 6-minutes. This feature can be reset at anytime to prevent accidental activation and battery depletion. The LaserLyte® CK-SWAT unit can also be easily removed and placed on any other compatible firearms.
The first of its kind laser for the very popular Bersa Thunder .380 and .380 Plus from LaserLyte®
LaserLyte® proudly introduces the CK-MS for the popular personal defense pistols, the Bersa® Thunder .380 and .380 Plus. The laser is easy and quick to mount on the Bersa trigger guard and snugs-up securely to the dust cover and simple to activate with the ambidextrous, ergonomic switch. The LaserLyte® CK-MS laser is easily programmable to either constant on or pulse mode. Another great feature is the “auto-off” feature that displays a unique flash after 5-minutes of operation and automatically turns the unit off after 6-minutes.
Constructed from T6 aluminum with a black chrome finish, the LaserLyte® CK-MS is durable and corrosion resistant. With the LaserLyte® CK-MS securely attached, the Bersa Thunder .380 or .380 Plus is the go-to personal defense pistol whether carried in a purse or stored for-the-ready in the home.